Sony Cable Box Universal Remote Codes

One of the best options for controlling all of your electric appliances with a single remote is to use a universal remote. We have chosen to share the Sony Cable Box Universal Remote Codes as a result. To ensure that everything is done correctly, we will offer the correct Sony cable box codes and the correct guidance. We can ensure that these codes will function properly because professionals have tested them. Check out how to immediately connect your remote control to your cable box.

Sony Cable Box Universal Remote Codes List

Brand	Code
Hamlin/Regal	222,223,224,225,226
Jerrold/G.I.	201,202,203,204,205,206,207,208,218
Oak	227,228,229
Panasonic	219,220,221
Pioneer	219,220,221,214,215
Scientific Atlanta	209,210,211
Tocom	216,217
Zenith	212,213

How to Program Sony Universal Remote Without Codes

All universal remote control codes are scanned in the remote during the auto-search procedure. To program the control, it scans one code at a time to find the proper remote code that works with your remote. Follow the instructions below:

• Turn on the smart device you wish to use the universal remote to control, such as the TV.
• To “turn on” a device, press and hold the TV, DVD, CBL, and OK/SEL buttons for 3 seconds. The device is ready to program, according to the LED light.
• Use the remote to choose the “CH+” and “CH-” switches. On/off indications are displayed on the remote. Continuously press the “up” or “down” key until the device turns off.
• Click the “power” key to confirm the code. It should start up. If it does, check a different channel to make sure the remote is programmed properly.

To store the code, press the “device” button now. The device’s LED will flash twice to verify the code that was saved.

How to Program Sony Universal Remote With Manual Method

The universal remote may be easily programmed using the keycode, which also helps to identify the manufacturer and model of your device.

• You must “Turn The Device On”.
• Press the “Sony universal remote” to “TV” mode.
• As soon as the universal remote displays the “Light Flash” (a sign that it is in “Learning mode”), push and hold the “Setup button” for a few seconds.
• Finally, enter the “Keycode” that you have obtained from the Instructions Booklet for programming.
• Simply “point your remote at the TV” after completing this step, and then “Press and Hold The Power” button.
• When the screen switches off, you can release the “Power Button”.

That’s all there is to it; your TV should now work perfectly with the universal remote control. If not, try repeating the process with a new code from the same section of the reference table.

How to Program Sony Universal Remote With Code Search

You can put your universal remote to search mode and look for the right key code if you cannot discover it at that moment. The remote control is forced into search mode by a code in the instructions.

• “Turn The Device On”.
• Hold down the “Setup” button for a moment.
• Enter the “9-9-1” (three-digit) code after which you must continue to hold down the “Power Button” on the remote control while pressing the Channel up button until the device, in this case your TV, “Turns Off.”

Finding your key code may take a little more time using the above-mentioned method, but it is very important. Your remote should function properly for all in-room operations once you have completed the previous steps.

Conclusion

All of this has to do with what is needed for programming the Sony universal remote. This is the time to use a single remote to enjoy a headache-free experience.

FAQs